Page 87 - CAT-027-6 IT.TE.DI. Catalog

CBN TEDI OCTO CUT - SETTING PROCEDURE
PRESETTING LENGTH
PRESETTING LENGTH 0 -0.003
Picture A
Check the height of the cartridges, the insert should stay under the presetting length.
PRESETTING LENGTH MAX 3μm AXIAL RUN-OUT
Picture C
Tighten the screw #3 at 12Nm, check again the presetting length; if needed, act on grubscrew #6 to keep the axial run-out in tolerance. Repeat the procedure for all the cartridges.
Picture B
Act the grub screw #6 and move the cartridge till the insert is about 3 μm from the final measure.
PRESETTING LENGTH SCRAPER
Picture D
Act the grub screw #6 and move the cartridge till the insert is about 3 μm from the final measure (+0.02 mm respect the presetting scraper length).
PRESETTING LENGTH 0.02
SCRAPER
Picture E
Tighten the screw #3 at 12Nm, check again the height; if needed, act on grubscrew #6 to keep the axial run-out in tolerance.
Repeat the procedure for all the wiper’s cartridges.
WIPER INSERTS
87
TECHNICAL